PPTP VPN Dialer Setup on XP (split tunnel)
We will create a regular VPN dialer with one note worthy exception, that we will set the system to NOT use it as the “Default Gateway” when connected.
Skipping this step will limit the connecting computer’s surfing speed to the VPN server’s upload speed (usually slow) because all of it’s traffic would be routed through the VPN connection and that’s not what we want.
We need to start the connection wizard, so we will go to control panel.
Go to “Start” and then “Control Panel”.
*If your system is setup with the “Classic Start Menu” you need to just point on the “Control Panel” icon and then select “Network Connections”.
In “Control Panel” double click “Network Connections”.
Double click “New Connection wizard”.
In the “New Connection wizard” welcome screen click “Next”.
Select the “Connect to the network at my workspace” option and then “Next”.
Select the “Virtual Private Network connection” option and then “Next”.
Give a name to the VPN connection.
Type in the name of your VPN servers DNS-name or IP address as seen from the Internet.
Optionally You may choose to “Add a shortcut to the desktop” and “Finish”.
Now comes the tricky part, it is vitally important you do NOT try to connect now and go into the dialer’s “Properties”.
Go to the networking tab and change the “Type of VPN” to “PPTP VPN” as shown in the picture below (this is optional but will shorten the time it takes to connect) then go into “Properties”.
On the next window go into “Advance” without changing anything else.
On the next window, uncheck the “Use default gateway on remote network” option.
Now enter the connection’s credentials as you set them on the server and connect.
That’s it, you should now be able to access all the computers on your network from the XP client… Enjoy.
Comments
(There are currently no comments for this post.)