Cisco Wireless 857w Configuration
Cisco 857w allows only 1 broadcast configurable SSID.
See the exact configuration set out below :
Keep in mind this is what is needed for the wireless part of the configuration and inside
NAT statement via Route-Maps is not included.
dot11 ssid COMMS
authentication open
authentication key-management wpa
guest-mode
wpa-psk ascii 0 test
interface Dot11Radio0
no ip address
!
encryption mode ciphers tkip
!
ssid test
!
speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0
station-role root
world-mode dot11d country GB outdoor
!
interface Dot11Radio0.1
encapsulation dot1Q 1 native
no cdp enable
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 spanning-disabled
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
!
interface Vlan1
description Bind_to_BVI1_Interface
no ip address
bridge-group 1
bridge-group 1 spanning-disabled
!
!
interface BVI1
description $ES_LAN$
ip address 192.168.194.1 255.255.255.0
ip nat inside
ip virtual-reassembly
!
ip dns server
ip nat inside source route-map NAT interface Dialer0 overload
!
route-map NAT permit 10
match ip address name NAT_ACL
!
ip access-list extended NAT_ACL
permit ip 192.168.194.0.0 0.0.0.255 any
!
bridge 1 protocol ieee
bridge 1 route ip